Rupert Neve Designs 542 Tape Emulator

LINE AMP NOISE
Rupert Neve Designs 542 Tape Emulator: Measurements with tape circuit disengaged. Measured at Main Output, un-weighted, 20 Hz – 22 kHz, Input Terminated 40 Ohm.
Unity Gain: Better than -100 dBV

FREQUENCY RESPONSE for Rupert Neve Designs 542 Tape Emulator
Measured at 10 dBu, trim at unity.
Main Output: /- 0.25 dB from 5 Hz to 60 kHz, -2 dB @ 120 kHz

MAXIMUM OUTPUT LEVEL
23.25 dBu

TOTAL HARMONIC DISTORTION AND NOISE
@ 1 kHz, 20 dBu output level: Better than 0.002%
@ 20 Hz, 20 dBu output level: 0.07% Typical (2nd and 3rd harmonic)

TAPE FX SPECIFICATIONS
NOISE
Measured at Main Output, un-weighted, 20 Hz – 22 kHz, Input Terminated 40 Ohm.
Saturation @ minimum: Better than -100 dBu
Saturation @ maximum: Better than -100 dBu

FREQUENCY RESPONSE
15 IPS, Input @ -0 dBu: -3 dBu @ 28 kHz
Saturation @ minimum: 0 dBu @ 10 Hz
5 dBu Peak @ 60 Hz Saturation @ maximum: -3 dBu @ 20 kHz
-3 dBu @ 12.5 Hz
2.4 dBu Peak @ 60 Hz

30 IPS, Input @ -0 dBu: -3 dBu @ 120 kHz
Saturation @ minimum: -3 dBu @ 10 Hz, 3.15 dBu Peak @ 125 Hz
Saturation @ maximum: -3 dBu @ 100 kHz
-3 dBu @ 12.5 Hz
1.3 dBu Peak @ 110 Hz

TOTAL HARMONIC DISTORTION AND NOISE
15 IPS
Input @ -0 dBu: 0.4% @ 3 kHz to 1% @ 175 Hz typical Saturation @ minimum: Greater than 1% below 175 Hz typical
Saturation @ maximum: 1% at 6 kHz typical, 0.3% @ 1 kHz to 3% @ 50 Hz typical

30 IPS
Input @ -0 dBu: 1% at 1 kHz typical
Saturation @ minimum: 0.6% @ 400 Hz to 5% @ 20 Hz typical
Saturation @ maximum: 1.5% @ 20 kHz to 0.4% @ 1 kHz typical, 0.4% @ 1 kHz to 2% @ 50 Hz typical

POWER REQUIREMENTS
Supplied by 500 series rack with 110-125 mA @ /- 16V DC